Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The Ventura Owner's Guide
We install and replace CWS-compatible driveway and paver systems throughout Ventura, with most driveway replacement projects falling between $5,000 and $14,000 and paver driveway installations running $7,000 to $18,000 depending on square footage and the condition of the base below. Most Ventura homeowners discover a failing paver or driveway surface the same way: a paver that has sunk an inch in one corner, a low spot that holds rainwater for days, or an edge that has started to crumble against the curb. What looks like a single broken paver usually points to what is happening underneath it, and that is where the real repair work begins.
Which CWS Models This Applies To
CWS driveway and paver systems in Ventura typically come from two product families: interlocking concrete pavers (often sold under the CWS PermaPave or CWS StoneScape lines) and poured concrete driveways poured under a CWS specification. If you are unsure which you have, check the edge of a paver for a stamped code, or look at the original invoice for a product number that starts with CWS-D (driveway) or CWS-P (paver). The older CWS StoneScape pavers from the mid-2000s used a 60mm thickness, while newer PermaPave runs 80mm, and mixing the two on a repair will create a visible height difference within a year. We carry both OEM CWS pavers when available and a quality aftermarket equivalent from a Ventura supplier that matches the 80mm PermaPave color range within one shade, which matters when the sun has faded the original pavers. Elmstead Remodeling Ventura is an independent service provider, not a CWS dealer or affiliate.
Styles & brands we work with
Signs Your CWS Driveway & Pavers Is Failing
- Pavers sinking in the wheel path. Car weight compresses a base layer that was never deep enough or has washed out. This is the most common CWS driveway failure in Ventura, especially on properties with clay-heavy soil that expands and contracts through winter rains.
- Standing water that stays for more than 24 hours after rain. The slope has flattened or the base has settled unevenly. Ventura's coastal fog and winter rain cycles accelerate this by keeping the sand between pavers damp for weeks at a time.
- Edges crumbling against the street or walkway. Without a proper edge restraint, the outer pavers drift and crack under turning tires. We see this constantly on older CWS installs where the original plastic edging has snapped.
- Weeds pushing up through joints in dense clusters. The polymeric sand between pavers has washed out or was never installed deep enough. Once roots establish, they lift the pavers from below and the surface begins to ripple.
- Concrete spalling or pitting across large sections. The surface has begun to fail from salt exposure, poor curing, or a too-wet original pour. In Ventura's marine air, concrete that was troweled too early shows this within five to seven years.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What's Included
Driveway replacement in Ventura runs $5,000 to $14,000 for a standard two-car concrete repour, and paver driveway installation runs $7,000 to $18,000 depending on whether we are reusing the existing base or rebuilding it from scratch. The biggest cost driver is what we find underneath the surface. If the original CWS install has a proper compacted base and edge restraint, repair is often a matter of pulling and resetting pavers. If the base has washed out, we are digging down 8 to 12 inches and rebuilding it before a single paver goes back. Every estimate is a written price before work starts, with the materials line broken out from labor so you can see exactly what you are paying for. The work is covered by our 365-Day Done Right Promise: if the driveway settles or a paver shifts within the year, we come back and make it right.
DIY or Call Us?
If a single paver has cracked, you can safely lift it with a flat pry bar and check what is underneath. What you cannot safely or usefully do yourself is rebuild a compacted base, re-slope a driveway that is holding water, or reset a large section that has drifted. The danger on driveway work is less about the pavers and more about what is under them: a base that has washed out can hide a void you cannot see from above, and once a section of interlocking pavers loses its edge restraint, removing the wrong paver will make the whole field shift. The heavy equipment, the base compaction, the proper sand and sealing work is a job for a trained crew. If you are unsure, call (341) 218-4316 and we will come look before you touch anything.
FAQs
A properly installed CWS paver driveway in Ventura should last 25 to 30 years before the base needs rebuilding, with paver replacement every 15 to 20 years. The marine air and occasional frost in the hills shorten that lifespan compared to inland California. Call (341) 218-4316 if you want us to inspect your base condition.
Yes, if the base is still stable and the edge restraint is intact, we can pull and reset individual pavers, re-sand joints, and re-seal the surface. If the base has washed out or the driveway has shifted more than an inch, replacement is the honest fix. We will tell you which one you need after looking at the site, and the inspection is free.
Most driveway replacements in Ventura take three to five working days from demolition to final seal, with the crew out of your way by the end of each workday. Paver driveways run closer to a week because of the base compaction time between lifts. We schedule around your family's routine and keep the site clean at the end of every day.
We keep common CWS 80mm PermaPave pavers in charcoal, tan, and a Ventura-gray blend on hand, and we can order less common colors within a week. We also stock the edge restraints and polymeric sand we install with them. Beyond CWS, we work with material partners like KraftMaid, Cambria, and Silestone on interior projects, so the same crew that does your driveway can handle your kitchen or bath if you ever need it.
If your CWS driveway or pavers are sinking, cracking, or holding water, call (341) 218-4316 for a free estimate. We will walk the site, write the scope and the price down before any work starts, and leave you with a driveway that drains properly and stays put. That is the standard we work to on every Ventura property.
Written by Graham Stein, Owner, Elmstead Remodeling Ventura at Elmstead Remodeling Ventura, serving Ventura and nearby areas.
